3Com WX2200 3CRWX220095A To clear the buffer, type the following command, Logging to the Console

Configuring and Managing the System Log 627

To filter the event log by MSS area, use the facility facility-namekeyword. For a list of facilities for which you can view event messages, type the following command:

WX1200# display log buffer facility ?

<facility name>	Select	one of: KERNEL, AAA,
SYSLOGD, ACL, APM, ARP, ASO, BOOT,		CLI, CLUSTER, CRYPTO,

DOT1X, NET, ETHERNET, GATEWAY, HTTPD, IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE, SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP, RAPDA, WEBVIEW, EAP, FP, STAT, SSHD,

SUP, DNSD, CONFIG, BACKUP.

To clear the buffer, type the following command:

WX1200# clear log buffer

To disable logging to the system buffer, type the following command:

WX1200# set log buffer disable

Logging to the Console

By default, console logging is enabled and messages at the error level and higher are sent to the console.

To modify console logging, use the following command:

set log console severity severity-level

(See Table 54 on page 624 for information on severity levels.)

For example, to set logging to the console for events at the critical severity level and higher, type the following command:

WX1200# set log console severity critical success: command accepted.

To disable console logging, type the following command:

WX1200# set log console disable success: change accepted.

The console is always available, but it has the following limitations:

„Console logging is slow.

„Messages logged to the console are dropped if the console output buffer overflows. MSS displays a message indicating the number of messages dropped.