3Com WX1200 3CRWX120695A, WXR100 3CRWXR10095A Reenabling Active, Scan, Enabling MAP, Signatures

582CHAPTER 26: ROGUE DETECTION AND COUNTERMEASURES

Disabling or	When active scanning is enabled, the MAP radios managed by the switch
Reenabling Active	look for rogue devices by sending probe any frames (probes with a null
Scan	SSID name), to solicit probe responses from other APs.
	Active scan is enabled by default. You can disable or reenable the feature
	on an individual radio profile basis. To disable or reenable active scan on a
	radio profile, use the following command:
	set radio-profile name active-scan {enable disable}
	The following command disables active scan in radio profile radprof3:
	WX1200# set radio-profile radprof3 active-scan disable
	success: change accepted.
Enabling MAP	A MAP signature is a set of bits in a management frame sent by a MAP
Signatures	that identifies that MAP to MSS. If someone attempts to spoof
	management packets from a 3Com MAP, MSS can detect the spoof
	attempt.
	MAP signatures are disabled by default. To enable or disable them, use
	the following command:
	set rfdetect signature {enable disable}
	The command applies only to MAPs managed by the WX switch on
	which you enter the command. To enable signatures on all MAPs in a
	Mobility Domain, enter the command on each WX switch in the Mobility
	Domain.
	You must use the same MAP signature setting (enabled or disabled) on all
	WX switches in a Mobility Domain.