3Com WXR100 3CRWXR10095A manual Transmit Rates, 11b-1.0,2.0, 11g-1.0,2.0,5.5,11.0, Beacon-rate

236CHAPTER 10: CONFIGURING MAP ACCESS POINTS

Table 19 Transmit Rates

Parameter	Default Value		Description
mandatory	„	11a— 6.0,12.0,24.0	Set of data transmission rates that
	„	11b—1.0,2.0	clients are required to support in order
			to associate with an SSID on a MAP
		11g—1.0,2.0,5.5,11.0
	„		radio. A client must support at least one
			of the mandatory rates.
			These rates are advertised in the basic
			rate set of 802.11 beacons, probe
			responses, and reassociation response
			frames sent by MAP radios.
			Data frames and management frames
			sent by MAP radios use one of the
			specified mandatory rates.
			The valid rates depend on the radio type:
			„	11a—6.0, 9.0, 12.0, 18.0, 24.0,
				36.0, 48.0, 54.0
			„ 11b—1.0, 2.0, 5.5, 11.0
			„	11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0,
				12.0, 18.0, 24.0, 36.0, 48.0, 54.0
			Use a comma to separate multiple rates;
			for example: 6.0,9.0,12.0
disabled	None. All rates applicable		Data transmission rates that MAP radios
	to the radio type are		will not use to transmit data. This
	supported by default.		setting applies only to data sent by the
			MAP radios. The radios will still accept
			frames from clients at disabled data
			rates.
			The valid rates depend on the radio type
			and are the same as the valid rates for
			mandatory.
			If you disable a rate, you cannot use the
			rate as a mandatory rate or the beacon
			or multicast rate. All rates that are
			applicable to the radio type and that are
			not disabled are supported by the radio.
beacon-rate	„	11a—6.0	Data rate of beacon frames sent by
	„	11b—2.0	MAP radios. This rate is also used for
			probe-response frames.
		11g—2.0
	„		The valid rates depend on the radio type

and are the same as the valid rates for mandatory. However, you cannot set the beacon rate to a disabled rate.