3Com WXR100 3CRWXR10095A Set boot backup-configuration filename, WX1200# clear boot backup-config

612CHAPTER 27: MANAGING SYSTEM FILES

Specifying a Backup In the event that part of the configuration file is invalid or otherwise Configuration File unreadable, MSS stops reading information in the configuration file and

does not use it. You can optionally specify a backup file to load if MSS cannot load the original configuration file.

To specify a backup configuration file, use the following command:

set boot backup-configuration filename

To specify a file called backup.cfg as the backup configuration file, use the following command:

WX1200# set boot backup-configuration backup.cfg success: backup boot config filename set.

After enabling this feature, you can specify that a backup configuration file not be used by entering the following command:

WX1200# clear boot backup-config

success: Backup boot config filename was cleared.

To display the name of the file specified as the backup configuration file, enter the display boot command. For example:

WX1200# display		boot	4.1.0.60
Configured boot		version:
Configured	boot	image:	wxb04102.rel
Configured	boot	configuration:	file:configuration

Backup boot configuration:	backup.cfg
Booted version:	4.1.0.60
Booted image:	wxb04102.rel
Booted configuration:	file:configuration
Product model:	WX

Resetting to the Factory Default Configuration

To reset the WX switch to its factory default configuration, use the following command:

clear boot config

This command removes the configuration file that the WX switch searches for after the software is rebooted.