A – Command Line Interface Reset Command
Q
Reset Command
Resets the switch configuration parameters. If you omit the keyword, the default is Reset Switch.
Authority Admin
Syntax reset
config [config_name] factory
port [port_number] snmp
switch (default) system zoning
Keywords config [config_name]
Resets the configuration given by [config_name] to the factory default values for switch, port, alarm threshold, and zoning configuration. If [config_name] does not exist on the switch, a configuration with that name will be created. If you omit [config_name], the active configuration is reset. You must activate the configuration for the changes to take effect. Refer to Table
factory
Resets switch configuration, port configuration, alarm threshold configuration, zoning configuration, SNMP configuration, system configuration, and zoning to the factory default values. The switch configuration is activated automatically. Refer to Table
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to Table
switch
Resets the switch without a
system
Resets the system configuration settings to the factory default values. Refer to Table
zoning
Clears the zoning database and deactivates the active zone set. The zoning configuration values (autosave, default visibility) remain unchanged.