Q-Logic 8C/16 Set Setup Command, Set setup, Snmp System, Table A-13. Snmp Configuration Settings

A – Command Line Interface Set Setup Command

Q

Set Setup Command

Changes SNMP and system configuration settings. The switch maintains one SNMP configuration and one system configuration.

Authority	Admin
Syntax	set setup
	snmp
	system
Keywords	snmp
	Prompts you in a line-by-line fashion to change SNMP configuration settings.
	Table A-13describes the SNMP fields. For each parameter, enter a new value or
	press the Enter key to accept the current value shown in brackets.
		Table A-13. SNMP Configuration Settings
	Entry		Description
	Contact		Specifies the name of the person to be contacted to respond to
			trap events. The default is undefined.
	Location		Specifies the name of the switch location. The default is
			undefined.
	Trap [1-5] Address		Specifies the workstation IP address to which SNMP traps are
			sent. The default address for trap 1 is 10.0.0.254. The default
			address for traps 2–5 is 0.0.0.0. Addresses, other than 0.0.0.0,
			for all traps must be unique.
	Trap [1-5] Port		Specifies the workstation port to which SNMP traps are sent.
			The default is 162.
	Trap [1-5] Severity		Specifies the severity level to use when monitoring trap events.
			The default is Warning
	Trap [1-5] Version		Specifies the SNMP version (1 or 2) to use in formatting traps.
			The default is 2.
	Trap [1-5] Enabled		Specifies whether traps (event information) are enabled or
			disabled (default).
	ReadCommunity		Read community password that authorizes an SNMP agent to
			read information from the switch. This is a write-only field. The
			value on the switch and the SNMP management server must
			be the same. The default is “public”.
	WriteCommunity		Write community password that authorizes an SNMP agent to
			write information to the switch. This is a write-only field. The
			value on the switch and the SNMP management server must
			be the same. The default is “private”.

A-42 59022-06 A