Q
A – Command Line Interface Set Config Command
Set Config Command
Sets switch, port, alarm threshold, and zoning configuration parameters.
Authority | Admin authority and a Config Edit session |
| |
Syntax | set config |
| |
| port [port_number] |
| |
| ports [port_number] |
| |
| switch |
| |
| threshold |
| |
| zoning |
| |
Keywords | port [port_number] |
| |
| Initiates an edit session in which to change configuration parameters for the port | ||
| number given by [port_number]. If you omit [port_number], the system begins with | ||
| port 0 and proceeds in order through the last port. For each parameter, enter a | ||
| new value or press the Enter key to accept the current value shown in brackets. | ||
| Enter “q” to end the configuration for one port, or “qq” to end the configuration for | ||
| all ports. Table | ||
| ports [port_number] |
| |
| Initiates an editing session in which to change configuration parameters for all | ||
| ports based on the configuration for the port given by [port_number]. If you omit | ||
| [port_number], port 0 is used. For each parameter, enter a new value or press the | ||
| Enter key to accept the current value shown in brackets. Enter “q” to end the | ||
| configuration. Table | ||
| Table | ||
|
|
|
|
| Parameter |
| Description |
|
|
|
|
| AdminState |
| Port administrative state: online, offline, |
|
|
| diagnostics, or down. The default is online. |
| LinkSpeed |
| Transmission speed: 1Gb/sec, 2 Gb/sec, |
|
|
| or Auto. The default is Auto. |
| PortType |
| Port mode: TL, GL, G, F, FL, Donor. The |
|
|
| default is GL. |
| ISLSecurity |
| E_Port security. Determines which |
|
|
| switches a port will establish a link with. |
|
|
| Any - link with any |
|
|
| switch. This is the default. |
|
|
| Ours - link only with an |
|
|
| compliant QLogic switch. |
|
|
| None - reject the link. |
| SymbolicPortName |
| Descriptive name. The default is Port. |
|
|
|
|