A – Command Line Interface Set Config Command
Q
Table A-10. Set Config Switch Parameters (Continued)
Parameter | Description |
|
|
DefaultDomainID | Default domain ID. The default is 1. |
DomainIDLock | Prevents (True) or allows (False) dynamic |
| reassignment of the domain ID. The |
| default is False. |
SymbolicName | Descriptive name. The default is |
| SANbox2. |
R_A_TOV | Resource Allocation Timeout Value. The |
| number of milliseconds the switch waits to |
| allow two ports to allocate enough |
| resources to establish a link. The default is |
| 10000. |
E_D_TOV | Error Detect Timeout Value. The number |
| of milliseconds a port is to wait for errors to |
| clear. The default is 2000. |
PrincipalPriority | The priority used in the |
| switch selection algorithm. 1 is high, 255 is |
| low. The default is 254. |
ConfigDescription | The name for the configuration. The |
| default is undefined. |
Propagates just the active zone set | |
| throughout the fabric (True, compliant) or |
| the entire zoning database (False, non- |
| compliant). The default is True. |
LegacyAddressFormat | Available only when the |
| Compliant parameter is False, this |
| parameter enables (True) or disables |
| (False) the use of legacy address |
| formatting for interoperating with |
| |
| Compliant” on page |
| False. |
|
|