Q
A – Command Line Interface Set Config Command
Table A-9. Set Config Port Parameters (Continued)
Parameter | Description |
|
|
MSEnable | Management server enable. Enables |
| (True) or disables (False) management |
| server on this port. The default is True. |
NoClose | Loop circuit closure prevention. Enables |
| (True) or disables (False) the loop’s ability |
| to remain in the open state indefinitely. |
| True reduces the amount of arbitration on a |
| loop when there is only one device on the |
| loop. The default is False. |
IOStreamGuard | I/O Stream Guard. Enable (Enable) or |
| disables (Disable) the suppression of |
| RSCN messages. The default is Disable. |
VIEnable | Enables (True) or disables (False) VI |
| preference routing. The default is False. |
| Enabling VIEnable will disable |
| MFSEnable. |
CheckAlps | Enables (True) or disables (False) the |
| loop’s ability to close more often. Enable |
| only for TL_Ports that are having problems |
| with a specific device. The default is False. |
|
|
switch
Initiates an editing session in which to change switch configuration settings. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.
Table A-10. Set Config Switch Parameters
Parameter | Description |
|
|
AdminState | Switch administrative state: online, offline, |
| or diagnostics. The default is Online. |
BroadcastEnabled | Broadcast. Enables (True) or disables |
| (False) forwarding of broadcast frames. |
| The default is True. |
InbandEnabled | Inband management. Enables (True) or |
| disables (False) the ability to manage the |
| switch over an ISL. The default is True. |
|
|
