![](/images/new-backgrounds/1106991/106991283x1.webp)
A – Command Line Interface Set Command
Q
port [option]
Sets port state and speed for the specified port temporarily until the next switch reset or new configuration activation. Refer to the ”Set Port Command” on page
setup [option]
Changes SNMP and system configuration settings. Refer to the ”Set Setup Command” on page
switch [state]
Temporarily changes the administrative state for all ports on the switch to the state given by [state]. The previous Set Config Switch settings are restored after a switch reset or a reactivation of a switch configuration. [state] can be one of the following:
online
Places all ports online
offline
Places all ports offline.
diagnostics
Prepares all ports for testing.
Examples The following examples enables and disables the beacon:
SANbox2 #> set beacon on
Command succeeded.
SANbox2 $> set beacon off
Command succeeded.