3Com WX1200 3CRWX120695A, WXR100 3CRWXR10095A, WX4400 3CRWX440095A Disabling or, Reenabling Radios

250CHAPTER 10: CONFIGURING MAP ACCESS POINTS

	To disable radio 1 on port 6 without disabling the other radios using radio
	profile rp1, type the following command:
	WX1200# set ap 6 radio 1 radio-profile rp1 mode disable
	(To disable or reenable all radios that are using a radio profile, see
	“Disabling or Reenabling All Radios Using a Profile” on page 250.)
Disabling or	You can disable or reenable radios on a radio profile basis or individual
Reenabling Radios	basis. You also can reset a radio to its factory default settings.
	(To disable or reenable radios when assigning or removing a radio profile,
	see “Assigning a Radio Profile and Enabling Radios” on page 249.)
Enabling or Disabling	To disable or reenable a MAP radio, use the following command:
Individual Radios	set ap apnumber radio {1 2} mode {enable disable}
	To disable radio 2 on port 3 and 6, type the following command:
	WX1200# set ap 3,6 radio 2 mode disable
	success: change accepted.

Disabling or Reenabling All Radios Using a Profile

To disable or reenable all radios that are using a radio profile, use the following command:

set radio-profile name [mode {enable disable}]

The following command enables all radios that use radio profile rp1:

WX1200# set radio-profile rp1 mode enable success: change accepted.

The following commands disable all radios that use radio profile rp1, change the beacon interval, then reenable the radios:

WX1200# set radio-profile rp1 mode disable success: change accepted.

WX1200# set radio-profile rp1 beacon-interval 200 success: change accepted.

WX1200# set radio-profile rp1 mode enable success: change accepted.