3Com WXR100 3CRWXR10095A, WX4400 3CRWX440095A manual Authentication Attributes for Local Users

488CHAPTER 21: CONFIGURING AAA FOR NETWORK USERS

Table 43 lists the authorization attributes supported by MSS. (For brief descriptions of all the RADIUS attributes and 3Com vendor-specific attributes supported by MSS, as well as the vendor ID and types for 3Com VSAs configured on a RADIUS server “Supported RADIUS Attributes” on page 651.)

Table 43 Authentication Attributes for Local Users

Attribute	Description	Valid Value(s)
acct-interim-inte	Interval in seconds	Number between 180 and 3600
rval	between accounting	seconds, or 0 to disable periodic
	updates, if start-stop	accounting updates.
	accounting mode is	Notes:
	enabled.
		„ The WX switch ignores the
		acct-interim-interval value and
		issues a log message if the value is
		below 60 seconds.
		„ If both a RADIUS server and the
		WX switch supply a value for the
		acct-interim-interval attribute,
		then the value from the WX switch
		takes precedence.
encryption-type	Type of encryption	One of the following numbers that
	required for access by	identifies an encryption algorithm:
	the client. Clients who	„ 1 — AES_CCM (Advanced
	attempt to use an
		Encryption Standard using Counter
	unauthorized
		with CBC-MAC)
	encryption method are
		„ 2 — Reserved
	rejected.
		„ 4 — TKIP (Temporal Key Integrity
		Protocol)
		„ 8 — WEP_104 (the default)
		(Wired-Equivalent Privacy protocol
		using 104 bits of key strength)
		„ 16 — WEP_40 (Wired-Equivalent
		Privacy protocol using 40 bits of
		key strength)
		„ 32 — NONE (no encryption)
		„ 64 — Static WEP
		In addition to these values, you can
		specify a sum of them for a
		combination of allowed encryption
		types. For example, to specify
		WEP_104 and WEP_40, use 24.