3Com WX1200 3CRWX120695A manual Parameter Default Value Frag-threshold 2346, Max-rx-lifetime 2000

210CHAPTER 10: CONFIGURING MAP ACCESS POINTS

Table 12 Defaults for Radio Profile Parameters (continued)

		Radio Behavior When Parameter Set to
Parameter	Default Value	Default Value
frag-threshold	2346	Uses the short-retry-count for frames shorter
		than 2346 bytes and uses the
		long-retry-count for frames that are 2346
		bytes or longer.
max-rx-lifetime	2000	Allows a received frame to stay in the buffer
		for up to 2000 ms (2 seconds).
max-tx-lifetime	2000	Allows a frame that is scheduled for
		transmission to stay in the buffer for up to
		2000 ms (2 seconds).
preamble-length	short	Advertises support for short 802.11b
		preambles, accepts either short or long 802.11b
		preambles, and generates unicast frames with
		the preamble length specified by the client.
		Note: This parameter applies only to
		802.11b/g radios.
qos-mode	wmm	Classifies and marks traffic based on 802.1p
		and DSCP, and optimizes forwarding
		prioritization of MAP radios for Wi-Fi
		Multimedia (WMM).
rfid-mode	disable	Radio does not function as a location
		receiver in an AeroScout Visibility System.
rts-threshold	2346	Transmits frames longer than 2346 bytes by
		means of the
		Request-to-Send/Clear-to-Send (RTS/CTS)
		method.
service-profile	No service	You must configure a service profile. The
	profiles defined	service profile sets the SSID name and other
		parameters.
wmm-powersave	disable	Requires clients to send a separate PSpoll to
		retrieve each unicast packet buffered by the
		MAP radio.

(To configure a radio profile, see “Configuring a Radio Profile” on page 240.)