3Com WXR100 3CRWXR10095A manual Auto-AP profile is not used to configure the MAP. Instead

224CHAPTER 10: CONFIGURING MAP ACCESS POINTS

	The MAP continues to operate without interruption after you enter the
	set ap auto persistent command. The next time the MAP is restarted,
	the Auto-AP profile is not used to configure the MAP. Instead, the
	persistent configuration is used. (Use the save config command to make
	the MAP configuration persistent across switch restarts.)
Configuring MAP Port	To configure a WX to connect to a MAP, see “Configuring a MAP” on
Parameters	page 224.

Optionally, you also can change other parameters that affect the entire

MAP:

„MAP name. (See “Changing MAP Names” on page 227.)

„Dual-home bias. (See “Changing Bias” on page 227.)

„Automatic firmware upgrade capability. (See “Disabling or Reenabling Automatic Firmware Upgrades” on page 228.)

„LED blink mode. (See “Enabling LED Blink Mode” on page 229.)

(For information about configuring RF Auto-Tuning settings on a radio, see Chapter 14, “Configuring RF Auto-Tuning,” on page 311.)

Table 17 lists how many MAPs you can configure on a WX switch, and how many MAPs a switch can boot. The numbers are for directly connected and Distributed MAPs combined.

Table 17 Configurable and Bootable MAPs per WX Switch

WX Switch Model	Maximum Configured	Maximum Booted
WX4400	300	24, 48, 72, 96, or 120 depending
		on the license.
WX2200	320	24, 48, 72, 96, or 120, depending
		on the license.
WX1200	30	12
WXR100	8	3

Configuring a MAP

Configure the MAP using the following command:

set ap apnumber serial-idserial-ID

model {2330 2330A AP2750 AP3750 mp-52 mp-241 mp-252 mp-262 mp-341 mp-352 mp-372 mp-372-CN mp-372-JP mp-422 mp-620} [radiotype {11a 11b 11g}]