3Com WX1200 3CRWX120695A, WXR100 3CRWXR10095A Displaying PoE State, Displaying Port Statistics

82CHAPTER 5: CONFIGURING AND MANAGING PORTS AND VLANS

Displaying PoE State

To display the PoE state of a port, use the following command:

display port poe [port-list]

To display PoE information for ports 1 and 3, type the following command:

WX1200# display port poe 1,3			Port	PoE	PoE
Port	Name	Link
		Status	Type	config	Draw
===================================================
1	1	down	MAP	disabled	off
3	3	up	MAP	enabled	1.44

In this example, PoE is disabled on port 1 and enabled on port 3. The MAP connected to port 3 is drawing 1.44 W of power from the WX switch.

(For more information about the fields in the output, see the Wireless LAN Switch and Controller Command Reference.)

Displaying Port Statistics

To display port statistics, use the following command:

display port counters [octets packets receive-errors transmit-errors collisions receive-etherstats transmit-etherstats] [port port-list]

You can specify one statistic type with the command. For example, to display octet statistics for port 3, type the following command:

WX1200# display port counters octets port 3			Tx Octets
Port	Status	Rx Octets

===============================================================================

3 Up 27965420 34886544

(For information about the fields in the output, see the Wireless LAN Switch and Controller Command Reference.)

To display all types of statistics with the same command, use the monitor port counters command. (See “Monitoring Port Statistics” on page 83.)