3Com WX4400 3CRWX440095A, WXR100 3CRWXR10095A, WX1200 3CRWX120695A Configuration Files, Running

Managing Configuration Files 609

Managing	A configuration file contains CLI commands that set up the WX switch.
Configuration Files	The switch loads a designated configuration file immediately after
	loading the system software when the software is rebooted. You also can
	load a configuration file while the switch is running to change the
	switch’s configuration.
	When you enter CLI commands to make configuration changes, these
	changes are immediately added to the device’s running configuration but
	are not saved to the configuration file.
	This section describes how to display the running configuration and the
	configuration file, and how to save and load configuration changes. A
	procedure is also provided for resetting the WX switch to its factory
	default configuration.
Displaying the	To display the configuration running on the WX switch, use the following
Running	command:
Configuration	display config [area area] [all]
	The area area parameter limits the display to a specific configuration
	area. (For more information, see the Wireless LAN Switch and Controller
	Command Reference.)
	The all parameter includes all commands that are set at their default
	values. Without the all parameter, the display config command lists
	only those configuration commands that set a parameter to a value other
	than the default.
	To display the running configuration, type the following command:

WX1200# display config

#Configuration nvgen'd at 2004-5-10 19:08:38

#Image 2.1.0

#Model WX1200

#Last change occurred at 2004-5-10 16:31:14 set trace authentication level 10

set ip dns server 10.10.10.69 PRIMARY set ip dns server 10.20.10.69 SECONDARY set ip route default 10.8.1.1 1

set log console disable severity debug set log session disable severity alert

set log buffer enable severity error messages 200 set log trace disable severity error mbytes 10