3Com WX1200 3CRWX120695A manual WX1200# display config area vlan, Save config filename

610CHAPTER 27: MANAGING SYSTEM FILES

set log server 192.168.253.11 severity critical set timezone PST -8 0

set summertime PDT start first sun apr 2 0 end lastsun oct 2 0 set system name WX1200

set system countrycode US set system contact 3Com-pubs

set radius server r1 address 192.168.253.1 key sunflower set server group sg1 members r1

set enablepass password b6b706525e1814394621eeb2a1c4d5803fcf set authentication console * none

set authentication admin * none

set user tech password encrypted 1315021018 press any key to continue, q to quit.

To display only the VLAN configuration commands, type the following command:

WX1200# display config area vlan

#Configuration nvgen'd at 2004-5-10 19:08:38

#Image 2.1.0

#Model WX1200

#Last change occurred at 2004-5-10 16:31:14 set vlan 1 port 1

set vlan 10 name backbone tunnel-affinity 5 set vlan 10 port 7

set vlan 10 port 8

set vlan 3 name red tunnel-affinity 5 set igmp mrsol mrsi 60 vlan 1

set igmp mrsol mrsi 60 vlan 10

Saving Configuration To save the running configuration to a configuration file, use the Changes following command:

save config [filename]

If you do not specify a filename of up to 128 alphanumeric characters, the command replaces the startup configuration file that was loaded the last time the software was rebooted. (To display the filename of that configuration file, see “Displaying Boot Information” on page 601.)

To save the running configuration to the file loaded the last time the software was rebooted, type the following command:

WX1200# save config

success: configuration saved.