3Com WX2200 3CRWX220095A manual Verifying a MAP Fingerprint on a WX Switch, MAP Can Establish

Configuring MAPs 231

Table 18 lists the MAP security options and whether a MAP can establish a management session with a WX based on the option settings.

Table 18 MAP Security Requirements

			MAP Can Establish
MAP Security	MAP Has	Fingerprint	Management
Setting	Fingerprint?	Verified in MSS?	Session with Switch?
MAP Security	Yes	Yes	Yes
Required
		No	No
	No	Not Applicable	No
MAP Security	Yes	Yes	Yes*
Optional
		No	Yes*
	No	Not Applicable	Yes

*MSS generates a log message listing the MAP serial number and fingerprint so you can verify the MAP’s identity. (See “Fingerprint Log Message” on page 233.)

Verifying a MAP Fingerprint on a WX Switch

To verify a MAP fingerprint, find the fingerprint and use the set ap fingerprint command to enter the fingerprint in MSS.

Finding the Fingerprint A MAP fingerprint is listed on a label on the back of the MAP. (See “Encryption Key Fingerprint” on page 230.)

If the MAP is already installed and operating, use the display ap status command to display the fingerprint. The following example shows information for Distributed MAP 8, including its fingerprint:

WX# display ap status 8

AP: 7, AP model: AP3750, manufacturer: 3Com, name: AP08 fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3

====================================================

State: operational (not encrypted)

CPU info: IBM:PPC speed=266666664 Hz version=405GPr id=0x29f1886d447f111a ram=33554432 s/n=0424000779 hw_rev=A3

Uptime: 1 hours, 8 minutes, 17 seconds

Radio 1 type: 802.11g, state: configure succeed [Enabled]

operational channel: 1 operational power: 1

base mac: 00:0b:0e:0a:60:00

bssid1: 00:0b:0e:0a:60:00, ssid: public