3Com WX2200 3CRWX220095A, WXR100 3CRWXR10095A manual Set mobility-domain member ip-addr

Configuring a Mobility Domain 155

Optionally, you can configure a redundant seed WX switch, which takes over seed duties if the primary seed becomes unavailable. See “Configuring Mobility Domain Seed Redundancy” on page 156.

Configuring Member To configure the list of members on the Mobility Domain seed for

WX Switches on the distribution to other member WX switches, use the following command Seed on the seed WX switch:

set mobility-domain member ip-addr

For example, the following commands add two members with IP addresses 192.168.12.7 and 192.168.15.5 to a Mobility Domain whose seed is the current WX:

WX1200# set mobility-domain member 192.168.12.7 success: change accepted.

WX1200# set mobility-domain member 192.168.15.5 success: change accepted.

Each command adds a member identified by its IP address to the list of Mobility Domain members. If the WX switch from which you enter the command is not configured as a seed, the command is rejected.

Configuring a To configure a member WX switch in the Mobility Domain, you enter the Member following command when logged in to the nonseed member WX switch:

set mobility-domain mode member seed-ip ip-addr

This command configures the IP destination address that the member WX switch uses when communicating with the seed WX switch.

For example, the following command configures the current WX switch as a member of the Mobility Domain whose seed is 192.168.253.6:

WX1200# set mobility-domain mode member seed-ip 192.168.253.6 success: change accepted.

This command sets the WX switch as a member of the Mobility Domain defined on the seed device at the identified address. If the WX switch is currently part of another Mobility Domain or using another seed, this command overwrites that configuration. After you enter this command, the member WX switch obtains a new list of members from its new seed’s IP address.