3Com WX1200 3CRWX120695A manual Displaying Dhcp, Server Information, Displayed instead

666CHAPTER E: DHCP SERVER

Displaying DHCP		To display information about the MSS DHCP server, use the following
Server Information		command:
		display dhcp-server [interface vlan-id] [verbose]
		If you enter the command without the interface or verbose option, the
		command displays a table of all the IP addresses leased by the server. You
		can use the interface option to display addresses leased by a specific VLAN.
		If you use the verbose option, configuration and status information is
		displayed instead.
		The following command displays the addresses leased by the DHCP server:
WX1200# display dhcp-server			MAC	Lease Remaining (sec)
VLAN	Name	Address
----	-------------- ---------------		----------------- --------------------
1	default	10.10.20.2	00:01:02:03:04:05	12345
1	default	10.10.20.3	00:01:03:04:06:07	2103
2	red-vlan	192.168.1.5	00:01:03:04:06:08	102
2	red-vlan	192.168.1.7	00:01:03:04:06:09	16789

The following command displays configuration and status information for each VLAN on which the DHCP server is configured:

WX1200# display dhcp-server verbose

Interface:		0 (Direct AP)
Status:	Range:		UP
Address			10.0.0.1-10.0.0.253
Interface:				default(1)
Status:	Range:			UP
Address				10.10.20.2-10.10.20.254
Hardware	Address:			00:01:02:03:04:05
State:	Allocation:			BOUND	seconds
Lease				43200
Lease	Remaining:			12345	seconds

IP Address:	10.10.20.2
Subnet Mask:	255.255.255.0
DNS Servers:	10.10.20.4 10.10.20.5
DNS Domain Name:	mycorp.com

In addition to information for addresses leased from the VLANs where you configured the server, information for the Direct AP interface is also displayed. The Direct AP interface is an internal VLAN interface for directly connected MAPs.