3Com WX1200 3CRWX120695A Save the configuration. Type the following command, Display Port status

102CHAPTER 5: CONFIGURING AND MANAGING PORTS AND VLANS

4Configure ports 5 and 6 as wired authentication ports and verify the configuration change. Type the following commands:

WX1200#	set port type wired-auth 5,6
success: change		accepted
WX1200#	display	port status	Config	Actual	Type	Media
Port Name		Admin Oper

===============================================================================

1	mgmt	up	up	auto	100/full	network	10/100BaseTx
2	finance	up	up	auto	100/full	ap	10/100BaseTx
3	accounting	up	up	auto	100/full	ap	10/100BaseTx
4	shipping	up	up	auto	100/full	ap	10/100BaseTx
5	lobby	up	up	auto	100/full	wired auth 10/100BaseTx
6	lobby	up	up	auto	100/full	wired auth 10/100BaseTx
7	conf_room1	up	up	auto	100/full	network	10/100BaseTx
8	conf_room1	up	up	auto	100/full	network	10/100BaseTx

5Configure ports 7 and 8 as a load-sharing port group to provide a redundant link to the backbone, and verify the configuration change. Type the following commands:

WX1200# set port-group name backbonelink port 7,8 mode on success: change accepted.

WX1200# display port-group

Port group: backbonelink is up

Ports: 7, 8

6Add port 1 to the default VLAN (VLAN 1) and verify the configuration change. Type the following commands:

WX1200# set vlan default port 1
success: change accepted.
WX1200# display vlan config			VLAN	Tunl			Port
VLAN	Name	Admin			Port	Tag
		Status	State Affin				State
----	----------------	------	----- -----		---------------- -----		-----
1	default	Up	Up	5	1	none	Up
4094	web-aaa	Up	Up	0
					2	4094	Up

7Save the configuration. Type the following command:

WX1200# save config

success: configuration saved.