3Com WX4400 3CRWX440095A manual Displaying Connection Information for Distributed MAPs

Displaying MAP Information 257

Displaying

Connection Information for Distributed MAPs

force-rebalance: NO,

Radio 2: type: 802.11a, mode: disabled, channel: dynamic

tx pwr: 17, profile: default

auto-tune max-power: default,

load-balance-group: ,

load-balance-enable: YES,

force-rebalance: NO,

local-switching: enabled, vlan-profile: locals

(For information about the fields in the output, see the Wireless LAN Switch and Controller Command Reference.)

To display connection information for Distributed MAPs configured on a WX switch, use the following command:

display ap global [apnumber serial-id serial-ID]

This command lists the System IP addresses of all the WX switches on which each Distributed MAP is configured, and lists the bias for the MAP on each switch. For each Distributed MAP that is configured on the switch on which you use the command, the connection number is also listed.

Connections are shown only for the Distributed MAPs that are configured on the WX from which you enter the command, and only for the Mobility Domain the WX is in.

To display connection information for all Distributed MAPs configured on a WX switch, type the following command:

WX4400# display ap global
Total number of entries: 8
AP	Serial Id	WX IP Address Bias
---	-----------	---------------	----
1	M9DE48B012F00	10.3.8.111	HIGH
-	M9DE48B012F00	10.4.3.2	LOW
2	M9DE48B123400	10.3.8.111	LOW
-	M9DE48B123400	10.4.3.2	HIGH
17	M9DE48B123600	10.3.8.111	HIGH
-	M9DE48B123600	10.4.3.2	LOW
18	M9DE48B123700	10.3.8.111	LOW
-	M9DE48B123700	10.4.3.2	HIGH