3Com WX2200 3CRWX220095A, WXR100 3CRWXR10095A manual Set rfdetect vendor-list client ap mac-addr

Configuring Rogue Detection Lists 575

If you add a device that MSS has classified as a rogue to the permitted vendor list, but not to the ignore list, MSS can still classify the device as a rogue. Adding an entry to the permitted vendor list merely indicates that the device is from an allowed vendor. However, to cause MSS to stop classifying the device as a rogue, you must add the device’s MAC address to the ignore list.

To add an entry to the permitted vendor list, use the following command:

set rfdetect vendor-list {client ap} mac-addr

The following command adds an entry for clients whose MAC addresses start with aa:bb:cc:

WX1200# set rfdetect vendor-list client aa:bb:cc:00:00:00 success: MAC aa:bb:cc:00:00:00 is now in client vendor-list.

The trailing 00:00:00 value is required.

To display the permitted vendor list, use the following command:

display rfdetect vendor-list

The following example shows the permitted vendor list on a switch:

WX1200# display rfdetect vendor-list Total number of entries: 1

OUI Type

----------------- ------

aa:bb:cc:00:00:00 client 11:22:33:00:00:00 ap

To remove an entry from the permitted vendor list, use the following command:

clear rfdetect vendor-list {client ap} {mac-addrall}

The following command removes client OUI aa:bb:cc:00:00:00 from the permitted vendor list:

WX1200# clear rfdetect vendor-list client aa:bb:cc:00:00:00 success: aa:bb:cc:00:00:00 is no longer in client vendor-list.