3Com WX2200 3CRWX220095A Setting a Port for a Wired Authentication User, Valid dap-num Values

Configuring and Managing Ports 75

Table 7 Valid dap-num Values

Switch Model	Valid Range
WX4400	1 to 300
WX1200	1 to 30
WXR100	1 to 8
WX2200	1 to 320

For the serial-idparameter, specify the serial ID of the MAP. The serial ID is listed on the MAP case. To display the serial ID using the CLI, use the display version details command.

The model and radiotype parameters have the same options as they do with the set port type ap command. Because the WX does not supply power to an indirectly connected MAP, the set ap command does not use the poe parameter.

To configure a connection for MAP 1, which is a MAP model MP-372 with serial-ID 0322199999, type the following command:

WX# set ap 1 serial-id 0322199999 model mp-372 success: change accepted.

Setting a Port for a Wired Authentication User

To set a port for a wired authentication user, use the following command:

set port type wired-auth port-list[tag tag-list][max-sessions num]

You must specify a port list. Optionally, you also can specify a tag-list to subdivide the port into virtual ports, and set the maximum number of simultaneous user sessions that can be active on the port. By default, one user session can be active on the port at a time.

The fallthru authentication type is used if the user does not support 802.1X and is not authenticated by MAC authentication. The default is none, which means the user is automatically denied access if neither 802.1X authentication or MAC authentication is successful.

To set port 17 as a wired authentication port, type the following command:

WX1200# set port type wired-auth 7 success: change accepted