3Com WX2200 3CRWX220095A, WXR100 3CRWXR10095A, WX4400 3CRWX440095A manual MAP Parameters

MAP Overview 183

MAP Parameters

Table 9 summarizes parameters that apply to individual MAPs, including dual-homing parameters. (For information about parameters for individual radios, see “Configuring a Radio Profile” on page 240 and “Configuring Radio-Specific Parameters” on page 246.)

Table 9 Global MAP Parameters

Parameter	Default value		Description
name	Based on the port or		MAP name.
	Distributed MAP connection
	number. For example:
	„	MAP01
	„	DAP01
bias	high		Setting a MAP’s bias on a
			WX switch to high causes the
			switch to be preferred over
			switches with low bias, for
			booting and managing the
			MAP.
			Note: Bias applies only to
			WX switches that are
			indirectly attached to the
			MAP through an
			intermediate Layer 2 or Layer
			3 network. A MAP always
			attempts to boot on MAP
			port 1 first, and if a WX
			switch is directly attached on
			MAP port 1, the MAP boots
			from it regardless of the bias
			settings.
group	None		Named set of MAPs. MSS
			load-balances user sessions
			among the access points in
			the group.
upgrade-firmware	enable		Automatic upgrade of boot
			firmware.
blink	disable		LED blink mode — blinking
			11a LED (AP2750) or health

and radio LEDs (MAP-xxx) make the MAP visually easy to identify.