Uniden DGA940 manual DESK/TABLETOP Installation, Set the base on a desk or tabletop with

Page 12

Before connecting your phone line, fully charge the Nickel- Cadmium battery pack for 15-20 hours.

Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

Use only the Uniden AC adaptor supplied with this phone plugged to uninterrupted power supply.

DESK/TABLETOP INSTALLATION

DC IN 10V

PULSE-TONE

TEL LINE

RINGER

OFF-ON

RESET

		Line in
	AC	From
	AC	Telephone
	Adapter	Telephone
	Adapter	Jack
		Jack

1. Snap the desktop/wall mount adaptor into the top of the base as shown.

2. Plug the AC adaptor cord into the 10V DC input jack on the back of the base.

3.Wrap the AC adaptor cord around the strain relief notch.

4.Plug the AC adaptor into a standard 240V AC wall outlet.

5.Charge the battery (See CHARGING THE BATTERY PACK, page 15).

6.Plug one end of the telephone cord into the TEL LINE jack on the back of the base.

7.Plug the other end of the cord into the telephone jack on the wall.

8.Set the base on a desk or tabletop with the

keypad facing up or down then place the handset into the base. Raise the antenna to a vertical position.

INSTALLATION & ADJUSTING

9

Image 12

Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Precautions PrecautionDo not short-circuit the battery Before you read anything else, please observe the followingImportant Safety Instructions PrecautionsAdditional Battery Safety Precautions Important Electrical ConsiderationsTelephone Line Problems Features IntroductionWelcome Included in Your Package Installing Installation ConsiderationsDESK/TABLETOP Installation Set the base on a desk or tabletop withWall Installation Standard wall plate mountingDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Charging the Battery Pack Initial battery chargingCharging optional battery pack Cleaning the Battery Contacts Setting the PULSE/TONE SwitchLow battery indicator With normal usage, your battery should last about one yearAdjusting Ringer Tone Handset ringer volumeHandset earpiece volume Base ringer volumeInstalling the Beltclip To attach the beltclipRemove the slot cover To remove the beltclipHeadset Installation Restore power to the baseTo reset the digital security code Automatic Digital Code SecurityUsing Making and Receiving CallsBasic phone operation If you are dialing in the pulse mode If you have Call Waiting service and aTone Flash and Call WaitingUsing the memory location features Dialing a Number in MemoryRemove the handset from the base One touch memory dialingDial the party or service main number Chain DialingTravelling OUT-OF-RANGE Pabx ConnectionIntegrated Answering Device Message counter LED turns offSetting the Clock Press skip or repeatPreset message Following message is pre-recordedPress and hold ogm until you hear Your message plays back for your reviewSetting the Ring Time Selecting the Message TimeSelecting a PIN Code To select a PINPlaying Your Messages Repeating a MessageSkipping a Message Deleting a MessageUsing the Reset Button Reset button is used to initialise the base computerRecording a Voice Memo System returns to StandbyRemote Access Away from Home Remote Switch OnRemote Room Monitor Other Functions Function PressTroubleshooting Quick Reference ChartFour minute option System does not Specifications GeneralBase Unit HandsetWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ