Uniden DGA940 manual Remote Room Monitor, Remote Access Away from Home, Remote Switch On

Page 35

REMOTE ROOM MONITOR

You may call your answering system from any touch tone phone to monitor sounds in the room where the base is installed.

1.Call your telephone number.

2.During the outgoing message playback, press # followed by your PIN code. (See SELECTING A PIN CODE, page 28.)

3.Press # then * while the system announces the time and date.

You will hear sounds in the room where your base unit is installed.

After 15 seconds, the answering system returns to the Command Waiting mode.

4.Press # then * to monitor the room for another 15 seconds. Or, select another remote function. Hang up to exit the system. The answering system automatically returns to Standby

REMOTE ACCESS AWAY FROM HOME

▼Remote Switch On

In the event that you forgot to turn on your answering machine before you leave home, you can switch it on from a remote location using a touch-tone phone.

1.Call your telephone number.

2.Wait for 15 rings.

3.The answering system announces the ogm.

4.Hang up. Your answering machine is ready to receive messages.

32

Image 35

Contents Page Functions Repeat Beltclip Holder Arging Contacts Contents Before you read anything else, please observe the following PrecautionsPrecaution Do not short-circuit the batteryPrecautions Important Safety InstructionsImportant Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Problems Welcome FeaturesIntroduction Included in Your Package Installation Considerations InstallingSet the base on a desk or tabletop with DESK/TABLETOP InstallationStandard wall plate mounting Wall InstallationDirect wall mounting Be careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Charging optional battery pack Charging the Battery PackInitial battery charging With normal usage, your battery should last about one year Cleaning the Battery ContactsSetting the PULSE/TONE Switch Low battery indicatorBase ringer volume Adjusting Ringer ToneHandset ringer volume Handset earpiece volumeTo remove the beltclip Installing the BeltclipTo attach the beltclip Remove the slot coverAutomatic Digital Code Security Headset InstallationRestore power to the base To reset the digital security codeBasic phone operation UsingMaking and Receiving Calls Flash and Call Waiting If you are dialing in the pulse modeIf you have Call Waiting service and a ToneOne touch memory dialing Using the memory location featuresDialing a Number in Memory Remove the handset from the basePabx Connection Dial the party or service main numberChain Dialing Travelling OUT-OF-RANGEMessage counter LED turns off Integrated Answering DevicePress skip or repeat Setting the ClockYour message plays back for your review Preset messageFollowing message is pre-recorded Press and hold ogm until you hearSelecting the Message Time Setting the Ring TimeTo select a PIN Selecting a PIN CodeRepeating a Message Playing Your MessagesDeleting a Message Skipping a MessageSystem returns to Standby Using the Reset ButtonReset button is used to initialise the base computer Recording a Voice MemoRemote Room Monitor Remote Access Away from HomeRemote Switch On Function Press Other FunctionsQuick Reference Chart TroubleshootingFour minute option System does not Handset SpecificationsGeneral Base UnitWarranty Warranty1800 632 Uniden Australia Pty Limited Part Code UCZZ01655BZ