EFJohnson 98x6, 98x3, 002-9803-601 manual Transmit Disable On Busy, Talk-Around

Page 46

CONVENTIONAL FEATURES

A conventional system must be selected to enable monitoring. If the microphone is taken off-hook with an LTR-Net or LTR system selected, scanning halts (unless off-hook detection is disabled) but monitoring is not selected.

Transmit Disable On Busy

The Transmit Disable On Busy feature automatically disables the transmitter if the selected group (channel) is busy and it has not been monitored when the PTT switch is pressed. When the trans- mitter is disabled by this feature, the busy tone sounds briefly and “DSBL BSY” is indicated on the lower line of the display.

While the PTT switch is pressed, the receiver is enabled so that activity on the channel can be monitored. The PTT switch must be released and then pressed again to make another call attempt. Occa- sionally, a busy condition may be detected even though no one is talking. To key the transmitter in this case, release the PTT switch and then immediately press it again.

There is also a programmable option with this feature to allow transmitting with a busy channel if the correct Call Guard signal is detected. The Transmit Disable On Busy feature is enabled or disabled on each conventional group by dealer programming. If this feature is disabled or if monitoring has been performed by taking the microphone off-hook, the transmitter keys even if the group is busy.

Talk-Around

Normally, all transmissions go through a repeater which usually increases range because the repeater transmits at a higher power level and has a higher antenna. However, this means that if you are out of radio range of the repeater, you cannot talk to anyone even if the mobile you are calling is only a short distance away. To allow communication if this occurs, talk-around groups can be programmed which enable direct mobile-to-mobile communication without going through a repeater.

46

Image 46
Contents LTR-Net 9800 Series Page Page Safety Information FCC Exposure Limits Frequency Whip Model No Base Model No Table of Contents Table of Contents Quick Reference Guide Features General FeaturesControls and Display Front Panel ControlsMicrophone Push-To-Talk PTT Switch Not Shown Push Rear Panel Jacks and Connectors Display Description Determining Volume Level Power-Up SequenceGeneral Operation Backlight Operation Numeric Display ModeAlpha Display Mode System/Group Display ModesSelect Mode Indication With Alpha Tag Display Select Mode Indication With Numeric DisplaySelecting the System and Group Setting Squelch Control Microphone Off-Hook DetectLTR-Net, LTR, and Conventional Operation IntroductionGeneral Features Bank SelectEmergency Switch Call IndicatorEncryption Function FCN Switch Home System/Group SelectHorn Alert Enabled Horn AlertPower Turn-Off Delay Option SelectProceed Clear-To-Talk Tone Receive-Only GroupsTime-Out Timer Stealth ModeTone Select General Standard Group CallsTransmitter Thermal Foldback Placing a Standard Group CallLTR-Net and LTR Operation Conventional OperationReceiving a Standard Group Call Telephone CallsPlacing Telephone Calls Receiving a Telephone Call LTR-NET Auxiliary Calls Landside-Originate Telephone CallsPlacing LTR-Net Auxiliary Calls Receiving Auxiliary CallsOption Switches Option Switches Menu ModeMenu Mode Introduction Menu Mode and Option Switch Functions SwitchUsing Menu Mode System and Group ScanningSystem and Group Scanning System and Group Scanning Scan List Programming Transmitting In The Scan Mode Scan Delay and Continue TimersLTR-NET and LTR Features Transmit InhibitCalls on Priority ID Codes Telephone Group SelectLTR-Net Standard and Special Calls LTR-NET FeaturesBusy Queuing Roaming Standard Group Calls LTR FeaturesConventional Features Telephone CallsMonitor Mode Selected Transmit Disable On Busy Talk-AroundCall Guard Squelch MiscellaneousSupervisory Tones Miscellaneous LTR-Net Special Call Tones LTR Telephone Call TonesDisplay Messages Miscellaneous Menu Mode Messages Bright DIM OFFSystem Operator Programming Speaking Into MicrophoneOperation At Extended Range Preventing Battery DischargeLicensing Transceiver Service Miscellaneous