•If you have not pressed any key for 30 seconds, the phone returns to the standby mode.
•If you get an incoming call, the operation
is canceled.
•If you select a memory location that does not have a stored number, the base will beep rapidly and the phone will not dial.
Chain Dialing
The memory locations in the handset are not limited to phone numbers. You can also store a group of numbers (up to 20 digits), that you need to enter once your call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store the special number in the Phonebook location (refer to “Storing Phone Numbers, Names, Distinctive Rings and Speed Dial” on page 26). Once you have called your bank, and when you are prompted to enter the
account number, press 
/RocketDial/ and use + or - to select the number in the Phonebook location, then press select/ch.
Memory Dialing (base only)
You can store 10 phone numbers in the base, and make calls with memory dialing from the base.
Storing Phone Numbers
1)Press memory in the standby mode.
2)Enter the number you wish to store. (The number cannot exceed 20 digits.)
3)Press memory. Enter the memory location number
• The 10 memory locations in the base are independent from the handset.
• The pause key counts as one digit. Pressing redial/p more than once increases the length of pause between numbers.
Making Calls with Memory Dialing
1)Press 
(talk) in the standby mode.
2)Press memory. Enter the memory location number
Deleting the Stored Data
1)Press memory in the standby mode.
2)Press memory again.
3)Enter the memory location number