Sharp MD-MT16H operation manual To turn off the power, To remove the MiniDisc

Page 13

To turn off the power:

Press the ■/:OFF button whilst in the stop mode.

●After the track number has been written on the disc, the power will shut off automatically.

(For details about the TOC, see page 21.)

To remove the MiniDisc:

Turn off the power and move the OPEN le- ver in the direction indicated by the arrow.

2

1

OPEN

■Recording from a tuner or a CD (Manual recording)

Manual recordings can be started and stopped as you like.

1 Place the unit in the recording stand-by mode.

(Perform steps 1 - 4 in the “Synchro recording” section.)

2 Press the 06 button.

●Recording will start.

●To record from a CD, press the 06 button, and then start playback on the equipment connected to this unit.

●Track numbers can be created whilst recording. (Page 18)

To interrupt recording:

Press the 06 button whilst recording.

●The unit will enter the recording stand-by mode.

●To resume recording, press the 06 button again.

The track number will be increased by one each time you interrupt a recording.

Recordings can not be made in the following situations:

●Recording on a playback-only MiniDisc (commercially available music).

●If a MiniDisc is protected against accidental erasure. (page 10)

About the recording level:

●If the recording level is too low, the playback sound volume may be too low to hear well. If it is too high, the playback sound may be greatly distorted. Since digitally recorded CDs have a large dynamic range (the volume can vary tremendously from very soft to extremely loud), do not set the recording level any higher than is necessary.

Precautions when recording:

●Do not jar or bump the main unit whilst recording. Otherwise, the recording may be unusable.

●Depending on the strength and type of playback signal in the original recording, the new recording may not begin or pause at the correct point when in the synchro mode.

If this happens, try making a manual recording.

Precautions when inserting a MiniDisc:

●To insert a MiniDisc, push on the middle of the edge of the disc whilst holding it parallel to the main unit.

●If any resistance is felt, do not try to force the MiniDisc into the unit, as it may cause damage to the unit. If resistance is felt, remove the MiniDisc and try reloading it.

12

* MD-MT16H FOR UK(01-21)

13

99.4.2, 0:57 PM

Image 13

Contents MD-MT16E Special Notes Service InformationMD-MT16H for UK01-21 99.4.2, 056 PM Accessories ContentsOptional Accessories IntroductionVolume setting PrecautionsConcern for others when listen- ing to MiniDiscs Precautions18 19 Names of Controls and IndicatorsAlkaline batteries power Power SourcePrecautions for alkaline battery use To the DC in 5V socket Rechargeable battery powerInsert securely 50/60 Hz All the way AC power About the rechargeable batteryDo not drop or subject the battery to shock Type of recording Before RecordingAnalogue recording Digital recordingRecordable MiniDisc Types of discsTo prevent recorded discs from being erased accidentally Playback-only MiniDiscRecording from CDs or MDs Synchro recording Recording Using the Analogue CableTo interrupt recording To stop recordingTo remove the MiniDisc To turn off the powerRecording from a tuner or a CD Manual recording There are cases where digital recording may be impossible Recording Using the Optical Digital CableStart recording Synchro recording Manual recordingRecording from the microphone Mic synchro recording Recording from the MicrophoneRecording from the microphone Mic manual recording To interrupt a synchro recordingTo interrupt a recording Press the /OFF buttonConvenient Recording Function Example when the setting is for 5 minutesAbout the timed auto mark Timed auto mark will be created every 5 minutesTo start recording from the middle of an existing track Recording tracks as a single trackMaking a track number automati- cally 1Press the Edit button whilst the recording is pausedTo check the remaining disc time Double time recording in monaural modeTo create your own track numbers whilst recording To erase all of the tracks at once To erase tracks To erase tracks one at a timeAbout Track Numbers When recording from digital inputs CDs/MiniDiscs onlyAbout the TOC When is the TOC recorded?About TOC recording Playing a Minidisc Playback does not start when a MiniDisc is insertedEarphones Track number Track nameTo stop playback To interrupt playback To remove the MiniDiscResume auto play function Convenient Playback Functions To play at double speed Mono recording only Random play or repeat playTo interrupt fast playback To display the playing time of an indi- vidual track To check the elapsed time and remaining time of the trackWhat the editing function can do EditingDisc/Track name Name/stampDivide MoveExample Combine When one or both tracks to be combined have a nameDisc name Following cases, tracks may not be combinedTrack name Type of characters Characters symbolsLights up To erase a characterTo delete characters To change disc names or track namesTo add characters Master MiniDisc RecordableMD-MT16H for UK22-42 99.4.2, 055 PM Listening through a car stereo Using with Other EquipmentHow to read the battery indicator Checking the remaining amount of battery levelConvenient Operation of the Unit To prevent the unit from being operated by mistakeWhilst in the stop mode To cancel the auto-play functionTo eliminate the confirmation sound Hold down the Mode button until SET UP appears To cancel the auto power save functionTroubleshooting What is a MINIDISC?If trouble occurs Minidisc System Limitations Blank Disc Error MessagesSpecifications MaintenanceCleaning GeneralMiniDisc Recorder A9904.TO Terms of Guarantee