Sharp MD-MT16H operation manual To interrupt playback To remove the MiniDisc, To stop playback

Page 24

To interrupt playback:

To remove the MiniDisc:

Press the 06 button during playback.

●To resume playback, press the 06 button again.

Turn off the power and move the OPEN lever in the direction indicated by the arrow.

To stop playback:

Press the ■/:OFF button.

To turn off the power:

Press the ■/:OFF button whilst in the stop mode.

●If the unit is not operated for at least 2 minutes whilst in the stop mode, the power will shut off automatically.

Resume auto play function:

●When you press the ■/:OFF button to stop playback, or when you turn the power off and then you resume playback, it will resume at the point on the MiniDisc where the playback was halted.

●If the MiniDisc is removed and inserted, and playback is resumed, playback will start from the first track.

Precautions when making connec- tions:

●Do not remove the rubber pads from the earphones.

●Be sure to hold the plug when removing it. If you pull on the lead, it may break, or the unit may malfunction.

Interrupted sound:

●This product is designed to eliminate interruptions in the sound which can be caused by vibrations.

However, if the unit is continuously ex- posed to vibrations or mechanical shock, the sound may be interrupted momentarily.

When the sound is distorted:

●If the volume is too high whilst the bass is being emphasised, the sound may be distorted, depending on the music on the track. If this happens, decrease the bass level or lower the volume level.

●If the volume is increased to “VOL 24” or higher, the bass level will be ad- justed automatically.

(This is done to reduce the distortion in the sound.)

Caution:

●When the unit is not to be used immediately after a MiniDisc has been inserted, or when you plan to carry the unit, turn off the power or cancel the auto-play function. Otherwise, the auto-play function will be activated and the battery will run down.

●Since the main unit and the AC adaptor can heat up during use, you should avoid allowing the unit to be in direct contact with your skin for any length of time.

When using the unit with a car adaptor:

●When you switch off the ignition key during playback, the power to this unit will also be turned off. Then, when the ignition key is switched on, playback will start from the beginning of the track where playback was halted (Resume auto-play function).

However, the power to the unit may not be turned off when the ignition is turned off, depending on the type of car.

23

* MD-MT16H FOR UK(22-42)

24

99.4.2, 0:55 PM

Page 23 Page 25
Image 24
Page 23 Page 25
Contents MD-MT16E Service Information Special NotesMD-MT16H for UK01-21 99.4.2, 056 PM Contents AccessoriesOptional Accessories IntroductionPrecautions Volume settingConcern for others when listen- ing to MiniDiscs PrecautionsNames of Controls and Indicators 18 19Power Source Alkaline batteries powerPrecautions for alkaline battery use Rechargeable battery power To the DC in 5V socketInsert securely 50/60 Hz All the way About the rechargeable battery AC powerDo not drop or subject the battery to shock Before Recording Type of recordingAnalogue recording Digital recordingTypes of discs Recordable MiniDiscTo prevent recorded discs from being erased accidentally Playback-only MiniDiscRecording Using the Analogue Cable Recording from CDs or MDs Synchro recordingTo interrupt recording To stop recordingTo turn off the power To remove the MiniDiscRecording from a tuner or a CD Manual recording Recording Using the Optical Digital Cable There are cases where digital recording may be impossibleStart recording Synchro recording Manual recordingRecording from the Microphone Recording from the microphone Mic synchro recordingTo interrupt a synchro recording Recording from the microphone Mic manual recordingTo interrupt a recording Press the /OFF buttonExample when the setting is for 5 minutes Convenient Recording FunctionAbout the timed auto mark Timed auto mark will be created every 5 minutesRecording tracks as a single track To start recording from the middle of an existing trackMaking a track number automati- cally 1Press the Edit button whilst the recording is pausedDouble time recording in monaural mode To check the remaining disc timeTo create your own track numbers whilst recording To erase tracks To erase tracks one at a time To erase all of the tracks at onceWhen recording from digital inputs CDs/MiniDiscs only About Track NumbersWhen is the TOC recorded? About the TOCAbout TOC recording Playback does not start when a MiniDisc is inserted Playing a MinidiscEarphones Track number Track nameTo interrupt playback To remove the MiniDisc To stop playbackResume auto play function Convenient Playback Functions Random play or repeat play To play at double speed Mono recording onlyTo interrupt fast playback To check the elapsed time and remaining time of the track To display the playing time of an indi- vidual trackEditing What the editing function can doDisc/Track name Name/stampMove DivideExample When one or both tracks to be combined have a name CombineDisc name Following cases, tracks may not be combinedType of characters Characters symbols Track nameLights up To erase a characterTo change disc names or track names To delete charactersTo add characters Master MiniDisc RecordableMD-MT16H for UK22-42 99.4.2, 055 PM Using with Other Equipment Listening through a car stereoChecking the remaining amount of battery level How to read the battery indicatorConvenient Operation of the Unit To prevent the unit from being operated by mistakeTo cancel the auto-play function Whilst in the stop modeTo eliminate the confirmation sound To cancel the auto power save function Hold down the Mode button until SET UP appearsWhat is a MINIDISC? TroubleshootingIf trouble occurs Minidisc System Limitations Error Messages Blank DiscMaintenance SpecificationsCleaning GeneralMiniDisc Recorder Terms of Guarantee A9904.TO
Top Page Image Contents