Heat Controller A-MMC18FA-1 manual Remote Control Operation, Cooling Model , Heat Pump Model

Operation

RemoteControlOperation

The Remote Controller transmits the signals to the system.

	1. START/STOP BUTTON
Signal transmitter	Operation starts when this button is
	pressed and stops when the button is pressed again.

5			1
6
			3
4
2		CANCEL	10
			9
7	OFF	SET
ON			12
11		AUTO CLEAN
8			15
			16

13 14

Flip-up door (opened)

Operation Mode

Cooling Operation

Auto Operation or Auto Changeover

Healthy Dehumidification Operation

Heating Operation

• Cooling Model(), Heat Pump Model( )

2. OPERATION MODE SELECTION BUTTON

Used to select the operation mode. (Heat Pump) (Cooling Only)

3. ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature.

4. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.

5. JET COOL

Used to start or stop the speed cooling/heating. (speed cooling/heating operates super high fan speed.)

6. CHAOS SWING BUTTON

Used to stop or start louver movement

and set the desired up/down airflow direction.

7.ON/OFF TIMER BUTTONS

Used to set the time of starting and stopping operation.

8.TIME SETTING BUTTONS Used to adjust the time.

9.TIMER SET/CANCEL BUTTON

Used to set the timer when the desired time is obtained and to cancel the Timer operation.

10.SLEEP MODE AUTO BUTTON

Used to set Sleep Mode Auto operation.

11.AIR CIRCULATION BUTTON

Used to circulate the room air without cooling or heating.

12.ROOM TEMPERATURE CHECKING BUTTON Used to check the room temperature.

13.RESET BUTTON

Used prior to resetting time.

14.2nd F Button

Used prior to using modes printed in blue at the bottom of buttons.

15.AUTO CLEAN

Used to set Auto Clean mode.

16.˚C TO ˚F SWITCHING BUTTON

Used to switch temperature reading from Centigrade to Fahrenheit.

Wall Mounted Multi-Zone Split System Air Conditioner - 48 -