Operating Instructions
Remote
Control
Operation
Controls
Signal transmitter
5 |
|
| 1 |
6 |
|
|
|
|
|
| 3 |
4 |
|
|
|
2 |
| CANCEL | 10 |
|
| ||
|
| 9 | |
7 | OFF | SET | |
ON | 12 | ||
11 |
| AUTO CLEAN | |
8 |
|
| 15 |
|
|
| 16 |
13 
14
Operation Mode 
Cooling Operation
Auto Operation or Auto Changeover 
Healthy Dehumidification Operation
Heating Operation
• Cooling Model(
), Heat Pump Model( 
)
1. START/STOP BUTTON
Operation starts when this button is pressed and stops when the button is pressed again.
2. OPERATION MODE
SELECTION BUTTON(Heat Pump) (Cooling Only)
Used to select the operation mode.
3. ROOM TEMPERATURE
SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.
5. JET COOL
Used to start or stop the speed cooling/heating.(speed cooling/heating operates super high fan speed.)
6. CHAOS SWING BUTTON
Used to stop or start louver movement
and set the desired up/down airflow direction.
7.ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation. (See page 18)
8.TIME SETTING BUTTONS
Used to adjust the time. (See page 18)
9.TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained and to cancel the Timer operation. (See page 18)
10.SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation. (See page 18)
11.AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating. (See page 19)
12.ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
13.RESET BUTTON
Used prior to resetting time.
14.2nd F Button
Used prior to using modes printed in blue at the bottom of buttons. (See page 17)
15.AUTO CLEAN
Used to set Auto Clean mode.
16.˚C TO ˚F SWITCHING BUTTON
Used to switch temperature reading from Centigrade to Fahrenheit.
Owner's Manual 11