Heat Controller DMH36TB-1 Always check for Install the drain hose to, Do not install the product

Page 6

Safety Precautions

Installation

Always check for

Install the drain hose to

Keep level even when

gas(refrigerant) leakage after

ensure that water is drained

installing the product.

installation or repair of

away properly.

 

product.

 

 

• Low refrigerant levels may cause

• A bad connection may cause

• To avoid vibration or water

product failure.

water leakage.

leakage.

90°

Do not install the product where the noise or hot air from the outdoor unit could offend neighbors.

It may cause a problem for your neighbors.

Use two or more people to lift

Do not install the product

and transport the air

where it will be exposed to

conditioner.

sea wind (salt spray) directly.

• Avoid personal injury.

• It may cause corrosion in the

 

product. Corrosion, particularly on

 

the condenser and evaporator fins,

 

could cause product malfunction

 

or inefficient operation.

Operation

Do not direct airflow at room occupants.

• This could damage your health.

Do not use the product for special purposes, such as preserving foods, works of art, etc. It is a consumer air conditioner, not a precision refrigeration system.

There is risk of damage or loss of property.

Do not block the inlet or outlet of air flow.

• It may cause product failure.

6Room Air Conditioner

Image 6
Contents Heat CONTROLLER, INC Important InformationTable of Contents Safety Precautions Do not handle the pipe by yourselfCostomer Do not allow water to run into electric partShock There is risk of electrical shockThere is risk of fire or electrical There could result in personal injury and product damageDo not install the product Always check for Install the drain hose toInstallation or repair Away properly Product Ensure that water is drainedBe careful and avoid personal injury There is risk of personal injuryThere is risk of personal injury and failure of product They may burn or explodePrior to operation Remote Controller Storage and Tips For Using the Remote ControllerOperating Instructions Signal Receptor Remote Control Operation Signal transmitterNd F Button Set the temperature lower than the room temperature Cooling OperationTemperature and fan speed are automatically set by Auto OperationFan speed mode is shifted Healthy Dehumidification OperationSound Beep sound Temperature can be set within a rangeHeating OperationHeat pump model only Of16C~30C60F~86F in 1C2FUnit will operate in high fan speed in cooling/heating mode Jet CoolOr or 2nd F Operation Setting the Time Additional featuresSleep Mode Delay Start/Pre-Set StopAir Circulation Mode Vertical Airflow Direction ControlAuto clean Forced OperationHeat pump Model Auto restart QuicklyDiscoloration Maintenance and ServiceIndoor Unit Volatile substancesDo not overcool the room Keep blinds or curtains When the air conditioner is to be used againClean the air filter regularly Closed UniformTroubleshooting Case Explanation SeeHeat CONTROLLER, INC
Related manuals
Manual 29 pages 18.54 Kb