Instructions to installation
3. Accessories for installation
No. |
| A | B | C | D | E | F |
Name | of | Adhesive | Connecting | Heat insulation | Gypsum | Drain hose | |
Parts |
| Tape | tape | Hose | material | powder |
|
|
|
|
|
|
|
|
|
4. Choose the installation place
Install the indoor unit where the weight of the unit can be supported.
Install the indoor unit where the heat source and steam source are not close and the unit inlet and outlet are not blocked.
Install the indoor unit where the drainage is easy and the outdoor unit can be easily connected.
Install the indoor unit where its cold air and hot air can be easily sent to all the corners of the room.
Install the indoor unit where the power socket is near and there is sufficient space around the indoor unit.
Install the indoor unit where there is no T.V set, radio set, and wireless appliance underneath, and the sunlight lamp is over one meter away.
If the remote controller is installed on the wall, the indoor unit shall be ensured to receive the signal while the sunlight lamp is on.
5.Installation procedure
1.Drill a hole in the wall and insert the connecting pipe and wire through a PVC
2.Before drilling check that there is no pipe or reinforcing bar just behind the drilling position. Drilling shall avoid at positions with electric wire or pipe.
3.Mount the unit on a strong and horizontal building roof. If the base is not firm, it will cause noise, vibration or pipe broken and refrigerant leakage (see Figure 6).
4.Support the unit firmly.
5.Change the form of the connection pipe, connection wire and drain pipe so that they can go through the wall hole easily.
Fig 1
14