Fan Speed, Filter Monitor, Temperature, Timer Delay

Fan Speed

NOTE: The Fan Speed button will operate only when the Cool, Fan or Heat (Heat/Cool models only) mode has been selected.

1.Press FAN SPEED until you see the indicator light glow for the desired setting.

2.Choose High, Med, Low or Auto.

■High – for maximum cooling or heating (Heat/Cool models only)

■Med – for normal cooling or heating (Heat/Cool models only)

■Low – for sleeping comfort

■Auto – automatically controls the fan speed depending on the current room temperature and temperature control setting

NOTE: Auto fan speed cannot be selected in Fan mode.

NOTE: After 5 seconds, the display will show the current room temperature.

Filter Monitor

1.When Filter Monitor indicator light is lit, remove, clean and replace air filter. See "Cleaning the Air Filter".

2.Press FILTER MONITOR after cleaning and replacing the air filter. This resets the filter monitor.

NOTE: After 360 hours of fan operating time, the filter indicator light will turn on. It will remain on for 180 hours or until you press FILTER MONITOR. After 180 hours, it will turn off automatically.

Temperature

■Press the plus TEMP button to raise the temperature. Each time you press or hold the plus TEMP button, the temperature will go up 1°F (1°C) until it reaches 90°F (32°C).

NOTE: After 5 seconds, the display will show the current room temperature.

■Press the minus TEMP button to lower the temperature. Each time you press or hold the minus TEMP button, the temperature will go down 1°F (1°C) until it reaches 64°F (18°C).

NOTE: After 5 seconds, the display will show the current room temperature.

■To change the temprature display from °F to °C.

NOTE: Press both pads at once to switch the display from °F to °C.

Timer Delay

To set the Timer for a 30-minute to 24-hour delay until the air conditioner turns off (the air conditioner must be On):

1.Press TIMER. Timer indicator light will flash. Display will show remaining hours before the air conditioner will turn off.

2.Press the plus or minus TEMP button to change the delay time from 30 minutes to 24 hours.

3.After 5 seconds, Timer indicator light will remain on. Display will show the current room temperature.

To set the Timer to turn on the air conditioner, keeping previous settings:

1.Turn off air conditioner.

2.Press TIMER. Timer indicator light will flash. Display will show remaining hours before the air conditioner will turn on.

3.Press the plus or minus TEMP button to change the delay time from 30 minutes to 24 hours.

4.After 5 seconds, Timer indicator light will remain on. Display will show the current room temperature.