Haier CWH24A, CWH12A, CWH18A manual Changing Air Direction, Exhaust Air Vent, Normal Sounds

Page 17

4.For Fan mode, adjust fan speed to High, Med or Low. NOTE: In Fan mode, temperature cannot be set.

5.For Smart System control, adjust fan speed to High, Med, Low or Auto.

6.For Dry mode and Smart System control, adjust temperature up or down by 4°F (2°C).

7.Turn off air conditioner.

8.Press TIMER. Timer indicator light on the air conditioner control panel will flash.

9.Press up or down arrow button to change the delay time from 30 minutes to 24 hours.

10.After 5 seconds, Timer indicato r light on the air conditioner control panel will remain on.

To clear Timer delay program:

NOTE: Air conditioner can be either on or off.

1.Press TIMER once after it has been programmed. Display will show remaining time.

2.While the display is showing the remaining time, press TIMER again. Timer indicator light will turn off.

To see or change the remaining time (in hours):

1.Press TIMER once after it has been programmed. Display will show remaining time.

2.While the display is showing the remaining time, press the up or down arrow button to increase or decrease the time.

3.After 5 seconds, the display will show the current room temperature.

Changing Air Direction

Use vertical level vane to direct the air right or left. Use the whole cartridge to direct air up, down or straight ahead.

A

 

A

 

A. Vertical Level Vane

A. Cartridge

 

Exhaust Air Vent

 

Pull out the exhaust air vent control to Open the exhaust air

A

vent and draw stale or smoky air from the room.

 

Push in the exhaust air vent control to close the exhaust air vent for maximum continuous cooling.

A. Exhaust air vent control

NOTE: The exhaust air vent control will function only when the

Fan Speed control is operating.

Normal Sounds

When your air conditioner is operating normally, you may hear sounds such as:

Droplets of water hitting the condenser, causing a pinging or clicking sound. The water droplets help cool the condenser.

Air movement from the fan.

Clicks from the thermostat cycle.

Vibrations or noise due to poor wall or window construction.

A high-pitched hum or pulsating noise caused by the modern high-efficiency compressor cycling on and off.

16

Image 17
Contents Climatiseurdepièce Table DES Matières Table of ContentsAIR Conditioner Safety Tools and Parts Through-the-Wall InstallationParts supplied Tools NeededLocation Requirements Window InstallationRecommended Grounding Method Power Supply CordElectrical Requirements Remove packaging materials To test your power supply cordUnpack the Air Conditioner Bottom view Window Installation-Prepare the CabinetBack view Window Installation-Position Cabinet in window Windowsill View Complete Window InstallationThrough-the-Wall Cabinet Installation Complete Installation Mode Starting Your Air ConditionerCool Only Models Timer Delay TemperatureFan Speed Filter MonitorTo clear Timer delay program Using the Remote ControlPower To see or change the remaining time in hoursSleep Control TimerSuper Control Normal Sounds Changing Air DirectionExhaust Air Vent Cleaning the Front Panel Cleaning the Air FilterRepairing Paint Damage Annual MaintenanceWater drips from cabinet into your house Air conditioner blows fuses or trips circuit breakersAir conditioner seems to run too much InCanada Assistance or ServiceIntheU.S.A Page Votre sécurité et celle des autres est très importante Sécurité DU ClimatiseurOutillage et pièces Exigences D’INSTALLATIONExigences d’emplacement 23 58,4 cm Installation dans une fenêtreExigences électriques Pour tester le cordon dalimentation Méthode recommandée de liaison à la terreCordon dalimentation Enlèvement des matériaux demballage Instructions DinstallationDéballage du climatiseur Vue de dessous Installationdans unefenêtre-Préparationde la caisseVue arrière Placez le boîtier dans la fenêtre Installation dans une fenêtre-Préparationde la fenêtreAchever l’installation sur la fenêtre Installation des rideaux latérauxVue du châssis de fenêtre Vue du seuil du châssis de fenêtreInstallation du cadre de bois Installation de la caisse dansun murOption 1-Moulure de bois, métal ou plastique Option 2-Mur de plâtre sans moulureInsérer le climatiseur dans la caisse Achever l’installationModèles du refroidissement seulement Utilisation DU ClimatiseurMise en marche du climatiseur Filter Monitor témoin du filtre Fan Speed vitesse du ventilateurMode Pour voir ou modifier le temps résiduel en heures Timer Delay minuterie différéeTempérature Système de commande Smart Utilisationde la télécommandePower alimentation Commande SuperTimer Minuterie Commande Sleep veilleVentilation Changement de direction de lairSons normaux Pour voir le temps résiduel en heures ou le modifierDépannage Entretien DU ClimatiseurLe climatiseur semble fonctionner trop longtemps AuCanada Assistance OU ServiceAuxÉtats-Unis Page Made In China