Honeywell TE831W-2 user manual Viewing Rain Statistics, Rainfall Memory Reset, Wind Window

Page 23

Viewing Rain Statistics

With the rain icon flashing Press either SET or MEMORY button to recall a rain statistics for the past hour, past 24 hours, yesterday, past week or past month.

Note: Last Hour rainfall value is displayed as a rate of rain in either “inch/hr” or “mm/hr”.

Rainfall Memory Reset

With the rain icon flashing, press and hold the MEMORY button to reset all rainfall statistics.

Setting Rain Display; inches or mm

With the rain icon flashing, press and hold the SET button to toggle rainfall data units between mm and inches.

Enabling or Disabling Daily Rainfall Alert

•With the rain icon flashing, press the ALARM/CHART button to display either the current rainfall statistics or the daily rainfall alert with “ALARM HI” displayed.

•If the alert is disabled, the “OFF” will be displayed; otherwise the rainfall alert value will be shown.

•When the rainfall alert is displayed, press the UP or DOWN arrow button to enable or disable it.

Setting up Daily Rainfall Alert

•With the rain icon flashing, press ALARM/CHART button to display the rainfall alert.

•Press and hold ALARM/CHART button until the rainfall alert “ALARM HI” will flash.

•Set the desired value for the Rainfall Alert by using UP or DOWN arrow button. Press and hold either button for fast digits advance.

•Press ALARM/CHART button to confirm selection and the unit will return to the rainfall alert display.

Disabling the Daily Rainfall Alert

In the Daily Rainfall Alert Mode press the ALARM/CHART button to disable the alert.

Wind Window

Wind direction is shown by compass points (i.e. NW) or in bearings starting from north (i.e. 22.5º). The unit displays

anemometer temperature or wind chill, average wind speed (over the past 10 minutes), gust, and wind other information. It 23

Image 23

Contents Honeywell Appendix City Codes Specifications Table of ContentsIntroduction Standard Package ContentsInstallation Before you begin Thermo-Hygrometer Sensors TS33C Battery installationMounting Placement tipsRain Gauge TS906 Battery installation Anemometer wind sensor TS805 Assembly Battery CoverWeather Main UnitTime Avoid placing the main unit in the following areas DisplayButtons and Controls Selects the next available window counter-clockwise Initial Set up Operation and Window Selection Clock and Alarms Window Clock and Calendar DisplaysSelecting Clock and Alarm Window Initial Settings City, Time, Date and LanguageCustom Weather Station Settings Pressure and Altitude Information Pressure and Weather Forecast WindowDisplay Select Pressure and Weather Forecast Window Changing Pressure and Altitude Parameters Changing or Setting Sea Level PressureChanging or Setting Altitude Viewing the Sea Level Pressure History Viewing the Pressure, Temperature and Humidity Bar ChartsViewing the Moon Phase History Moon Phase DiagramWeather Forecast Displays Temperature and Humidity Window Temperature in Celsius or Fahrenheit Display Selecting Temperature and Humidity WindowViewing Temperature and Humidity for each Channel Temperature and Dew Point DisplaysRain Window Programming Upper and Lower limits for Temperature AlarmDisabling Temperature Alarm levels Viewing the Max/Min Channel Temperature and HumidityViewing Rain Statistics Rainfall Memory ResetSetting Rain Display inches or mm Setting up Daily Rainfall AlertSelecting Wind Window Configuring Wind DisplaySetting Wind Speed in km/h, mph, m/s or knots Resetting the Wind Statistics MemoryDisabling the Wind Alert Enable/Disable Time AlarmsProgramming Time Alarms Wind Alert programmingAtomic Time Reception Disable/Enable Snooze functionDisable alarms Activate Search for Remote Sensors Memory Reset ProcedureMaintenance Remote Sensor StatusTroubleshooting Weather forecast is inaccurate PrecautionsAppendix City Codes Specifications Hardware Requirement for WeatherCapture PC software Power 12 AA Batteries includedWind Speed RainfallDimensions Battery life alkalineWeight without batteries Declaration of Conformity