Honeywell TE831W-2 Memory Reset Procedure, Maintenance, Remote Sensor Status, Changing Batteries

Page 27

Remote Sensor Status

The wave icon above the current channel display shows the connection status of the corresponding remote sensor:

Activate Search for Remote Sensors

Normally the main display will automatically find and display measurement results from the remote sensors. However, occasionally other radio transmission sources (TV, Cordless or Cell Phones etc) can interrupt the sensor signal. If this happens simply press and hold the DOWN arrow button for 4 – 6 seconds to activate a new search.

Memory Reset Procedure

These steps will completely reset all of the parameters stored in memory.

•On the main unit press and hold SNOOZE and UP buttons for 4 seconds until the backlight will flash

•Press SET button clearing the memory -the main unit will start beeping with 1 second delay.

•Wait until the beeping will cease

•Disconnect main unit from the AC/DC adapter and remove the batteries from the back of the main display unit and wait 10 seconds

•Reinstall the batteries and reconnect the main unit to the wall power outlet through the AC/DC adapter

Maintenance

Changing Batteries

The battery status of each weather sensor is checked every hour. If the low battery indicator lights up, replace the batteries in the corresponding unit.

27

Image 27

Contents Honeywell Appendix City Codes Specifications Table of ContentsStandard Package Contents InstallationIntroduction Before you begin Thermo-Hygrometer Sensors TS33C Battery installationPlacement tips Rain Gauge TS906Mounting Battery installation Anemometer wind sensor TS805 Assembly Battery CoverMain Unit TimeWeather Avoid placing the main unit in the following areas DisplayButtons and Controls Selects the next available window counter-clockwise Initial Set up Operation and Window Selection Clock and Alarms Window Clock and Calendar DisplaysSelecting Clock and Alarm Window Initial Settings City, Time, Date and LanguageCustom Weather Station Settings Pressure and Weather Forecast Window Display Select Pressure and Weather Forecast WindowPressure and Altitude Information Changing or Setting Sea Level Pressure Changing or Setting AltitudeChanging Pressure and Altitude Parameters Viewing the Sea Level Pressure History Viewing the Pressure, Temperature and Humidity Bar ChartsViewing the Moon Phase History Moon Phase DiagramWeather Forecast Displays Temperature and Humidity Window Temperature in Celsius or Fahrenheit Display Selecting Temperature and Humidity WindowViewing Temperature and Humidity for each Channel Temperature and Dew Point DisplaysRain Window Programming Upper and Lower limits for Temperature AlarmDisabling Temperature Alarm levels Viewing the Max/Min Channel Temperature and HumidityViewing Rain Statistics Rainfall Memory ResetSetting Rain Display inches or mm Setting up Daily Rainfall AlertSelecting Wind Window Configuring Wind DisplaySetting Wind Speed in km/h, mph, m/s or knots Resetting the Wind Statistics MemoryDisabling the Wind Alert Enable/Disable Time AlarmsProgramming Time Alarms Wind Alert programmingDisable/Enable Snooze function Disable alarmsAtomic Time Reception Activate Search for Remote Sensors Memory Reset ProcedureMaintenance Remote Sensor StatusTroubleshooting Weather forecast is inaccurate PrecautionsAppendix City Codes Specifications Hardware Requirement for WeatherCapture PC software Power 12 AA Batteries includedWind Speed RainfallBattery life alkaline Weight without batteriesDimensions Declaration of Conformity