Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR | ||
|
WIRE DRIVE MOTOR REMOVAL AND REPLACEMENT PROCEDURE
(CONTINUED)
FIGURE F.14 – CASEFRONT KNOB REMOVAL
Nameplate
Control Knob
LINCOLNELECTRIC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
5/64” Allen | Phillips | |
Set Screw | ||
Screws | ||
|
1.Remove the input power to the machine.
2.Perform the Case Cover Removal Procedure.
WARNING
ELECTRIC SHOCK can kill.
• Have an electrician install and service this equipment. Turn the input power OFF at the fuse box before working on equipment. Do
not touch electrically hot parts.
3.Remove the two phillips screws from the gun trigger receptacle.
4.Remove the two set screws from the voltage and wire speed knobs using a 5/64” allen key. Remove the two nuts and washers using a 1/2” Nutdriver. See Figure F.14.
5.Remove the two phillips head screws from the nameplate of the machine. See Figure F.14.
6.Gently pull the case front forward about an inch to gain access.
7.Disconnect the air line from the wire drive motor. Pliers may be necessary.
8.Label and disconnect any necessary leads. The number of leads may vary depending upon the machine’s model number.
9.Remove the three phillips mounting screws from the right side of the machine. See Figure F.15.
10.Remove the Wire Drive Motor and replace.