Epson 7600, 9600 service manual Error Display, Errors, Error Indications on LCD

EPSON Stylus Pro 7600/9600 Revision A

3.2 Error Display

The printer displays the relevant error message on the LCD and the error status by LEDs. At the same time, it stops not only printing operation but also receiving data from the host PC. (Among the interface signals, the “-ERROR” signal is turned “low” and the “BUSY” signal is turned “high” to inhibit data input.)

3.2.1 Errors

Errors, Warnings and service call errors (fatal errors) are described below.

3.2.1.1 Error Indications on LCD

Table 3-1. Error Indications on LCD

LCD Panel Message		Printer Status	Refer to
SERVICE REQ. nnnnnnnn	Fatal error*
COVER OPEN	Cover open error		p.127
LOAD PAPER	Paper set lever is released during operation		p.126
PAPER JAM	Paper jam		p.127
INK OUT	Ink out error		p.130
NO INK CARTRIDGE	No ink cartridge		p.130
INVALID CARTRIDGE		Wrong ink cartridge	p.130
SET INK CARTRIDGE	Defective ink cartridge		p.131
PAPER OUT	Paper out error		p.126
	• Ink sequence currently executed
COMMAND ERROR	•	Paper currently initialized	–
	•	Timer IC reset
		/NVRAM clear
	• Wrong setting with roll paper and sheet
LOAD XXX PAPER		(Roll paper)	p.126
	• Wrong setting with roll paper and sheet
		(Sheet)
RELOAD PAPER	Problem with paper output (sheet)		p.129
MAINTENANCE TANK FULL	Maintenance tank full		p.131
PAPER NOT CUT	Paper cutting error		p.128

Table 3-1. Error Indications on LCD (continued)

LCD Panel Message	Printer Status	Refer to
LOWER PAPER SET LVR	Paper set lever is released	p.127
REMOVE PAPER	Paper is too thick for cleaning
RELOAD PAPER	Paper check error	p.129
PAPER NOT STRAIGHT	Paper not straight	p.128
INVALID CARTRIDGE	Non-genuine cartridge	p.130
SET INK LEVER	Ink lever released	p.130
NO MAINTENANCE TANK	No maintenance tank	p.131
COMMAND ERROR	Command error	p.131
OPTION I/F ERROR	Type-B I/F error	p.128

Note : The status can't be replied during service call.

Troubleshooting Error Display 123