Epson 7600, 9600 service manual Cutter Positioning Adjustment, Cutter Holder Assy height adjustment

EPSON Stylus Pro 7600/9600 Revision A

5.3.7 Cutter Positioning Adjustment

This adjustment should definitely be mad if the following parts are removed.

Parts		Adjustment Items
Cutter Solenoid Assy	1.	Paper Guide L up and down adjustment
	2.	Cutter Holder ASSY height adjustment
Paper Guide L	1.	Paper Guide L up and down adjustment

This adjustment is intended to install the cutter at a proper position and height relative to the step for the cutter on the Paper Guide L. The number of adjustment items required depends on the parts replaced. Carry out work by referring to the table above.

† Adjusting tools: Cutter positioning jig #F800

NOTE: For disassembly and assembly procedure, refer to “Cutter Holder ASSY (p.175)”.

CHECK	For adjustments at replacing the Cover Sensor ASSY, make the
POINT	Paper Guide L up and down adjustment first and then make the
	Cutter Holder ASSY height adjustment.

1.Remove the H Top Cover. (p.165)

NOTE: For Stylus Pro 9600, remove also the H Top Cover (p.165) and the Tube Cover (p.193).

2.Open the Front Cover, and remove the cutter.

3.Return the CR Unit to the cap position and set the cutter positioning tool at the right end of the Paper Guide L. (See Figure 5-73)

4.Loosen the screws securing the Paper Guide L.

NOTE: 3 screws for Stylus Pro 7600 / 5 screws for Stylus Pro 9600

CHECK	To loosen the screw at the left end of the Paper Guide L, pass the
POINT	screwdriver through the cut portion of the I/H Frame Top Plate.
	(See Figure 5-72)

Cutter Holder ASSY height adjustment

Paper Guide L up and down adjustment

Figure 5-71. Cutter Positioning Adjustment

Cut portion of I/H Frame

Figure 5-72. Removing the screw for Paper Guide L (at left end)

Adjustment Mechanism Adjustment 269