Epson 9600, 7600 service manual Cutter position adjustment, Auto margin refresh

EPSON Stylus Pro 7600/9600 Revision A

1.4.3.12 Cutter position adjustment

Cutter position can be adjusted with this mode. Cutter position adjustment pattern is printed, and the cutter is adjusted with cutter position number entered by users.

NOTE: This adjustment is effective for top/bottom no margin print.

†Setting procedure

1.Set paper.

2.Enter Cutter position adjustment menu with the panel.

3.Print cutter position adjustment pattern.

4.Select the best pattern number and enter the number.

NOTE 1: When “1 cut” is selected with panel, it is not operated.

2:Setting value can be selected from 1 to 17 with “Paper Feed” button.

†Level structure of Cutter position adjustment menu

Pause

READY
	††††††† †
			Source
SelecType		Paper
PRINTER SETUP			Source
SelecType		Paper
PRINTER SETUP
	CUTTER ADJ
SelecType		Paper Source
CUTTER ADJ
		EXEC
Enter		PRINTING ALGNMNT
		PATTERN
CUTTER ADJ
	*8

†Cutter position adjustment pattern

„	Output paper size	: A4
„	Font	: Built-in font
„	Print sample	: See following picture.

Figure 1-10. Cutter position adjustment pattern

„Number in print pattern and cutter position

Number in print pattern	1	2	3	...	...	15	16	17
Adjustment value				...	...

1.4.3.13 Auto margin refresh

When this setting is ON, paper edge is automatically cut to prevent print dirt after 4 sides no margin print. The cutting length is depends on the minimum cut length at this time.

Product Description Operating Panel 44