Epson 9600, 7600 CR Encoder Scale Timing Fence, Fastening Spring on the L Side Frame side

EPSON Stylus Pro 7600/9600 Revision A

4.3.10 CR Encoder Scale (Timing Fence)

CAUTION „ When unlocking the carriage, do not move the carriage by about 2 cm or more with the cutter pushed into the innermost

position; otherwise, the cutter edge would be damaged.

„ Take great care not to scratch the CR Encoder Scale. (If the CR

Encoder Scale is scratched, the encoder sensor will output wrong signals, thus resulting in abnormal operation of the carriage or error occurrence.)

1.	Remove the R Side Cover. (p.160)
2.	Remove the L Side Cover. (p.163)
3.	Remove the I/H Cover. (p.164)
4.	Remove the H Top Cover. (p.165)

CR Encoder Scale Fastening Spring

CR Encoder Scale

5.	Remove the CR Encoder Sensor ASSY. (p.178)
6.	Disengage the CR Encoder Scale (Timing Fence) from the CR Encoder Scale
	Fastening Spring on the L Side Frame side.
7.	Remove the CR Encoder Scale from the CR Encoder Scale Holders.

NOTE: The number of CR Encoder Scale Holders is as follows:

Stylus Pro 7600: 2 guides

Stylus Pro 9600: 3 guides

8.While pushing the cutter area gently, shift the carriage to the left about 2 cm to unlock the carriage and then move the carriage to the left from the capping position.

(See Figure 4-24)

9.Disengage the CR Encoder Scale from the hook on the CR Encoder Scale Holder R and draw out the CR Encoder Scale from the carriage area.

ADJUSTMENT	After assembling the CR ENC, the following adjustments should be
REQUIRED	made.
	„ “5.1.4.8 CR Encoder Sensor ASSY Adjustment (p.215)”

CR Encoder Scale Holder

Figure 4-48. Releasing from the CR Encoder Scale Fastening Spring

CR Encoder Scale

CR Encoder Scale Holder R

Figure 4-49. CR Encoder Scale Removal

Disassembly & Assembly Disassembly and Assembly of Carriage (CR) Mechanism 184