Epson 7600, 9600 service manual Adjustment Tools, Name Part Code, MCSP24R4, MCSP44R4

EPSON Stylus Pro 7600/9600 Revision A

5.1 Overview

This section describes the adjustment procedures necessary after replacing certain parts and explains how to perform those adjustment procedures.

5.1.1 Cautions

Before beginning the adjustment operation, be sure to confirm the following caution items.

CAUTION „ If you are carrying out adjustments, see “5.1.4 Adjustment

Items” (p.212) and then confirm the relevant adjustment items and adjustment procedures.

„ When carrying out adjustments, check the cautions displayed in the explanation for each adjustment item thoroughly. If the operation is performed wrong, it could hinder the product's operation or functions.

5.1.2 Adjustment Tools

CHECK	In adjustments and test printing, use Doubleweight Matte Paper
POINT	roll, unless otherwise specified.

Table below lists the tools necessary for adjustments of Stylus Pro 7600/9600.

Table 5-1. Adjustment Tools

Name	Part Code	Notes
Tension Gauge	1060744 / standard tool	2.2kgf ± 220g
#F770	acceptable	(PF Belt tension)
Thickness gauge	Commercially available	Thickness:
		0.3 / 0.4 / 0.8 / 0.9 mm
Coupling tightening jig		Tightening force: 3kgf + 500g

Table 5-1. Adjustment Tools (continued)

Name		Part Code	Notes
24/44-inch Width Roll Paper	Epson or commercially		For printer mechanism
	available paper		adjustments and test printing.
	(Doubleweight Matte
	Paper roll)
	•	MCSP24R4
		(24-inch width)
	•	MCSP44R4
		(44-inch width)
A3Tracing Paper	1057723		Used for adjustment of the
#F751			paper status detection sensor
			(P_REAR) level adjustment.
			Microtrace #300 LMB, made
			by Kimoto
A3 Copy Paper (PPC)	Commercially available		Used for adjustment of the
	product		paper status detection sensor
	(Example: Fuji Xerox		(P_EDGE) level adjustment.
	Bright Recycled)
Scale 1000mm	1047746 / A		Length:1000mm
#F713	commercially available
	scale can be purchased.
Scale Stopper	1047745 / A		Used in combination with the
#F714	commercially available		#F713 (measurements in 0.1
	scale can be purchased.		mm units)
CR ENC sensor positioning jig	1212926
#F799
Cutter Positioning Jig	1212928
#F800
PF ENC sensor positioning tool	1212925
#F798
Ink Cartridge (x7)*			Spare
Draining cartridge*			Use at black ink type change
Maintenance Tank*			Spare

Note "*": Use at adjustments which require test printing.

Adjustment Overview 211