Epson 9600, 7600 service manual „ Removing and installing the Rear Cover

EPSON Stylus Pro 7600/9600 Revision A

4.2.6 Rear Cover

1.From the rear side, remove two screws (CPS: M3⋅12), and remove the blank panel. (See Figure 4-16)

2.Remove the two screws (CP: M3⋅6) securing the parallel interface and remove the one

screw (CBS: M3⋅6) securing the USB interface.

3.Remove one screw (CBS: M3⋅6) holding the AC inlet top. (See Figure 4-17)

4.Remove the three screws (CBS: M4⋅8) (six screws for Stylus Pro 9600) holding the rear cover bottom.

5.Open the Roll Paper Cover.

6.Remove the three screws (CBS: M4⋅8) (six screws for Stylus Pro 9600) holding the rear cover top, then remove the rear cover, while pulling it rearward.

CAUTION To avoid getting hurt with sharp frame edges, be sure to wear gloves when performing the following work:

„Removing and installing the Rear Cover

Screws (CPS: M3⋅12) ⋅2

Screws(CPS: M3⋅6) ⋅2

Blank Panel

Screw (CPS: M3⋅6)

„ Inserting your hand through the opening in the Access Cover (see Check Point on the next page)

Figure 4-16. Rear Cover Removal 1/2

Screw (CPS: M3⋅6)

Screws(CPS: M4⋅8) ⋅3

Screws (CPS: M4⋅8) ⋅3

Figure 4-17. Rear Cover Removal 2/2

Disassembly & Assembly Removing the Panel Unit and Housing 166