Epson 9600, 7600 service manual Mounting Plate Gauge Condition, Lcd

EPSON Stylus Pro 7600/9600 Revision A

8.Set the 0.9-mm thickness gauge between the PF Grid Roller and the Driven Roller near the detection arm on the paper transport path, and bring down the Paper Set Lever toward you (to the “paper holding” position).

At this point, if the value on the LCD is not “11”, loosen the screw securing the mounting plate for the P_THICK Sensor (right). Then slide the mounting plate to a position where the LCD shows “11”, tighten the screw and remove the 0.9-mm thickness gauge.

9.Set the 0.8-mm thickness gauge the same way as above and make certain that the value on the LCD is “01”.

At this point, if the value on the LCD is not “01”, loosen the screw securing the mounting plate for the P_THICK Sensor (right). Then slide the mounting plate to a position where the LCD shows “01”, tighten the screw and check the previous step again.

10.Turn the power switch Off, then after disconnecting the power cable, install the H Top Cover.

Table 5-30.

Mounting Plate	Gauge	Condition	LCD
			Indication
P_THICK_0.3 Sensor Mounting	0.3 mm	Paper thickness	00
Plate (left)		0.3 mm or below
	0.4 mm	Paper thickness	01
P_THICK Sensor Mounting Plate	0.8 mm	0.4 ∼ 0.6 mm
(right)	0.9 mm	Paper thickness	11
		0.7mm or above
		Lever in “Up” position	10
		(Paper released)
–
		Lever in "Down" position	00
		(Paper held)

CAUTION

Take care not to bend thickness gauges by, say, dropping. This adjustment requires an accuracy to units of 0.1 mm.

Adjustment Mechanism Adjustment 266