Epson 9600, 7600 service manual Type-B I/F error, Paper cutting error, Paper Not Straight

EPSON Stylus Pro 7600/9600 Revision A

3.2.2.7 Type-B I/F error

	Table 3-11.
Item	Description
LCD PANEL	OPTION I/F ERROR
MESSAGE
LED STATUS	None
	A non-supported option Type-B I/F card is installed into the
Explanation	printer.
	This error occurs when the printer is turned on.
	Turn off the printer, remove the option Type-B I/F card, and then
Recovery	turn on again.
	If the error recurs, repeat checking by installing another Type-B
	interface.

3.2.2.8 Paper cutting error

	Table 3-12.
Item	Description
LCD PANEL	PAPER NOT CUT
MESSAGE
LED STATUS	“PAPER OUT” LED is blinking.
Explanation	The paper cannot cut whole paper completely by the cutter, or cut
	paper remains over the front paper sensor.
	† Remove the cut paper, or cut manually the paper using scissors
	or else. User should lift the paper set lever and reset the paper or
	push the Pause button. Thereby the printer will execute paper
	initialize operation and will be printable status. In this time, if
	the paper is so disarranged that it may cause head friction or
Recovery	paper jam, user should cut the disarranged part neatly and reset
	the paper. User should replace the cutter blade if it becomes
	dull.
	† Checking the operation of the Cutter Solenoid:
	Execute “Actuator 2 (p.229)” in the self-diagnostics menu and if
	any problem is found, replace the actuator.

3.2.2.9 Paper Not Straight

	Table 3-13.
Item	Description
LCD PANEL	PAPER NOT STRAIGHT
MESSAGE
LED STATUS	“PAPER OUT” LED is blinking.
	When a skew exceed 3mm between top and end of the paper is
Explanation	occur, user should confirm the previous printout because it may
	not be printed completely. And also smudges on back of following
	printouts may occur because of poured ink on the platen.
	This error is cleared by paper set operation.
	• User should set the paper according the description of User's
	guide exactly in order to prevent the occurrence of this error.
Recovery	• The roll edge should be neatly arranged.
	• This error can be prevented at following printing by paper set
	operation.
	This error may also cleared by turning OFF→ ON, but this error
	may occur at following printing.

Troubleshooting Error Display 128