Epson 7600, 9600 Feed Correction + T&B Adjustment, Display Adj Feed Adj.+T&B, To be placed

EPSON Stylus Pro 7600/9600 Revision A

FEED CORRECTION + T&B ADJUSTMENT

1.Start the Self-diagnostic Function:

Power OFF → [Paper Feed ∆]+[Paper Feed ∇]+[Cut/Eject] → Power ON

2.Display “Adj: Feed Adj.+T&B”:

[Paper Feed ∇] → [SelecType >] → [Paper Feed ∆] x6

3.Print the pattern.

[SelecType >] →[Enter ↵] when “[Enter] Adjust Print” is displayed (See Figure 5-32)

4.Measure the top margin:

Using a measuring rule, measure the top margin. Input the measured value on the panel.

5.Measure the bottom margin:

Using a measuring rule, measure the bottom margin. Input the measured value on the panel.

6.Measure the side margin:

Using a measuring rule, measure the side margin. Input the measured value on the panel.

7.Measure the feed correction value:

Using a measuring rule (1000 mm) and the scale stopper, measure the longitudinal line length. Input the measured value on the panel.

CHECK	„ The central print pattern among the patterns as shown above is
POINT	intended for use as a datum line on which the measuring rule is
	to be placed.

„Even if you have left the “Feed Correction + T&B Adjustment” mode by mistake, you can restore the relevant adjustment display without reprinting the pattern, by pressing [Paper Source <] when “[Enter] Adjust Print” is displayed.

Bottom margin (14.0mm)

Longitudinal line length (1000.0mm) Paper Feed Direction

Top margin (3.0mm)	Side margin
	(3.0mm)

Figure 5-33. Print Pattern for Feed Correction + T&B Adjustment

Adjustment Self-diagnostic Function 241