Epson 7600, 9600 BI-D Adjustment Procedure, Display Adj Bi-d, † K Black Line Adjustment Procedure

EPSON Stylus Pro 7600/9600 Revision A

BI-D ADJUSTMENT PROCEDURE

1.Start the Self-diagnostic Function:

Power OFF → [Paper Feed ∆]+[Paper Feed ∇]+[Cut/Eject] → Power ON

2.Display “Adj: Bi-d”:

[Paper Feed ∇] → [SelecType >] → [Paper Feed ∇] x9

3.Print the 240, V1 black line pattern:

Press [Enter ↵ ] when “240V1 K PRN” is displayed. (See Figure 5-47)

4.Check the test pattern (240, V1 K)

Check to see if the line by the first pass and the line by the second pass are not in alignment.

When they are in alignment, proceed to the next step. If they are not in alignment, make the adjustment by referring to the procedure described below. (See Figure 5-49)

†K (Black Line) Adjustment Procedure

1.Display the value input screen “240V1 K: xx”:

After the test pattern has been output, press [SelecType >] one time when “240V1 COL PRN” is displayed on the LCD.

2.Input the value:

In consideration of the output pattern, input a value in the range of +99∼–99 and press [Enter ↵ ].

3.Output the pattern again:

[SelecType >] → [SelecType >] → [Enter ↵ ]

4.Check the pattern:

Check the output pattern and repeat the K (black line) adjustment until the line by the first pass and the line by the second pass are in alignment.

CHECK	Be sure to make adjustment for K first and then for other colors.
POINT	Each color pattern has been set based on K. Therefore, if the K
	value is not correct, you can not make adjustments for color
	patterns correctly.

Figure 5-48. Bi-D Adjustment Patterns

2nd pass (– side)

Enlarged

2nd pass (+ side)

1st pass

Figure 5-49. Round Trip Print Position (Bi-D) Adjustment (Black)

Adjustment Self-diagnostic Function 249